Euroflex vapour M2R Manual De Instrucciones página 8

1
1
Assembly of Parts & Preparation of Steamer
ASSEMBLY OF PARTS & PREPARATION OF STEAM CLEANER
Make sure all parts are in the box (see pg 4).
Make sure all parts are in the box (see pg 6).
IMPORTANT: FOLLOW THESE INSTRUCTIONS CAREFULLY!
IMPORTANT: FOLLOW THESE INSTRUCTIONS CAREFULLY!
A. Assemble Handle
A. ASSEMBLE HANDLE
After removing Handle Assembly from carton:
"Maximum Extension" Position
"Maximum Extension" Position
IMPORTANT
*IMPORTANT*
*
Front steam jets will only operate when Extension Tube is in the "Maximum
Frontal steam can only be generated when Extension Tube is in the
Extension" position. BE SURE EXTENSION TUBE IS FULLY EXTENDED
"Maximum Extension" position. BE SURE EXTENSION TUBE IS FULLY
AND LOCKED IN PLACE FOR OPTIMAL STEAM OPERATION. Do not
EXTENDED AND LOCKED IN PLACE FOR OPTIMAL STEAM OPERATION.
remove Handle Assembly once attached to steam cleaner.
8
Before Use
After removing Handle Assembly from carton:
• Pull Extension Tube apart until you see the lock opening 1. Pull Extension Tube apart until you see the lock opening
(hole) on the Tube.
(hole) on the Tube.
Line up the peg on Locking Clamp with the
2. Line up the peg on Locking Clamp with the

hole on Extension Tube and...
hole on Extension Tube and...
*

Pull apart Extension Tube
Pull apart Extension Tube
snap the Locking Clamp closed, to lock
3. Snap the Locking Clamp closed, to
lock the Extension Tube in position.
the Extension Tube in position.

5
Before Use