Publicidad
Idiomas disponibles
Idiomas disponibles
CHAPTER 5
INSTALLATION
Remove the packaging and check that the machine is undamaged. In particular, look for any possible
damages caused by transport. If in doubt, do not use the machine and refer to the manufacturing company.
Place
Position the machine in a place with low humidity percentage and far from heat sources.
DO NOT INSTALL THE MACHINE IN AN EXPLOSIVE ATMOSPHERE.
DISCONNECT THE POWER SUPPLY PLUG FROM THE MAINS BEFORE STARTING ANY CHECKING
OPERATION WHICH MAY REQUIRE PARTS DISASSEMBLY.
B
1
A
Fig. 2
Connections
Before starting the machine, check the oil level through the sight glass located on the motor (fig. 2, detail
1). Loosen the 4 screws locking the casing and remove it to reach the sight glass (models with oil bath
vacuum pumps).
Note
BEFORE CONNECTING THE VACUUM PACKAGING MACHINE, MAKE SURE THAT THE PLATE DATA
CORRESPONDS WITH THE SUPPLY MAINS DATA.
The plate is located on the side of the casing.
After level checking and casing re-installation, connect the plug to a current outlet 220V.
If it is not possible to connect the plug and the outlet, the outlet must be replaced with the correct one by
professionally qualified personnel who should also check that the outlet cable section is correct for machine
power consumption.
It is not advisable to use adapters, multiple outlets and/or extensions.
If this should be the case, use only simple or multiple adapters and extensions in accordance with the safety
standards in force.
Do not exceed current capacity limit and maximum power level marked on the multiple adapter.
Publicidad
