Fimar BAR300P Uso Y Mantenimiento página 22

WORKING CYCLE SETTING FOR BAR350-400
Through the switch on of the machine, a dash/line in the centre of the display
shows the stand-by phase.
MANUAL CYCLE: pressing Start/Stop button, a time endless working cycle is
on ( A letter for aspiration is shown on the display).Once wished vacuum level
is obtained in the bag, the operator will press SET/SEAL button to let the
sealing phase start, with automatic switch off of the pump.
AUTOMATIC CYCLE: when machine is in stand-by, dash/line in the centre of
the display will be positioned on MAN: pressing START/STOP, the operator will
place the dash/line on AUT1 or AUT2.Automatically, the electronic board will
show time sealing (DEFAULT 3,5 sec),which can be modified..
Pressing START/STOP suction phase begins, and after 15 secs (AUT1) or 25
secs (AUT2) machine will automatically pass to sealing and then download thus
end working cycle phases.
EXTERNAL TECHNICAL COMPONENTS
PICT B
PICT C
4
3
2
1
5
6