Fimar BAR300P Uso Y Mantenimiento página 21

CONTROL PANEL LEGEND 300P-350-400
7. START/STOP button to start the vacuum
phase, after placing the open mouth of the bag until reference point on the lower
plate bag
8. SEAL button to seal the vacuum bags when the vacuum phase is over. Since the
sealing phase doesn't start automatically, you always have to push this button to
get a manual activation of the sealing phase.
9. Button for the start of the working cycle: if pressed twice, it stops any
working activity.
10. When the machine is not running, it enables the selection of
programs AUT 1 (15 secs- vacuum cycle) and AUT 2 (25 secs- vacuum
cycle). At the end of these 2 programs, machine will automatically seals
the vacuum bag.
11. Button for the start of sealing process during manual working
cycle. When machine is not running, this function enables the
selection and
12. Display: it shows with A the suction/aspiration phase and the time
previously set during sealing phase. Default sealing time 3,5 secs
RECOMMENDED BAGS
We recommend using gofer bags (thickness 100 µ) available in our warehouse in any size.
It is possible to use regular smooth bags (thickness 140 µ) making sure that lateral bag
borders are folded in order to obtain the suction channels.
WORKING CYCLE
• Put the product inside the vacuum bag
• Place the open side of the bag on the lower plate, up to the reference bar
• Lower the plate/bar, press START button, and press on the 2 marked
labels 'PUSH', in order to activate decompression phase and keep the bar
closed
• When air is totally sucked, press button 2 (image A) to start sealing
phase. The machine will stop the process automatically.
• In 6/7 sec, air re-intake will enable the chamber opening
1
5
2
setting of sealing time.
3
4