Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use
EN
3. Clean and dry mop pads after dust emptying
After the robot finishes a cleaning task and returns to the base station to
charge, the base station will automatically start emptying the dust bin, and
then clean and dry the mop pads.
Note:
·
When the robot returns midway to the base station to clean mop pads, the base
station will not automatically empty the dust bin.
·
If the auto-empty function is turned off in the app, the base station will not
automatically empty the dust bin.
·
The base station will empty the dust bin according to the frequency set in the app.
4. Clean the used water tank
After the robot has completed the task, please clean the used water tank to
avoid any odor.
14
Sweeping
1. To use only the sweeping function, select "Sweeping" on the app, or remove
the mop assembly from the robot and the robot will automatically switch to
the sweeping mode.
Note: If the mop assembly is not removed from the robot, you can select the
sweeping mode on the app, and the robot will automatically lift the mop assembly
before sweeping.
2. Make sure that the base station is connected to power and the robot is
connected with the base station. Press the button
on the robot, or use the
app to send the robot to clean all areas from the base station.
Note: To ensure the robot can easily return to the base station after cleaning, it is
recommended to make the robot start from the base station and avoid moving the
base station during cleaning.
Routine Maintenance
Parts
To keep the robot in good condition, it is recommended to refer to the following table for routine maintenance.
Replacement
Part
Maintenance Frequency
Period
Used water tank
After each use
/
Clean water tank
Main Brush
Every 6 to 12 months
Once every 2 weeks
Dust bin filter
Every 3 to 6 months
Side brush
Washboard
Base station's
signaling area
Base station's
charging contacts
Base station's auto-
Once every month
/
empty vent
Universal wheel
Edge sensor
Laser Distance
Sensor (LDS)
Maintenance
Replacement
Part
Frequency
Period
Carpet Sensor
Cliff Sensors
Charging Contacts on Robot
Bumper
Once every month
/
Robot's auto-empty vent
Robot's automatic water
refilling inlet
Bottom of the robot
Dust bin
Clean it as needed
Dust collection bag
6-8 weeks
/
Every 1 to 3
Mop pad
months
Note: The replacement frequency will depend on your usage of the robot. If an
exception occurs due to special circumstances, the parts should be replaced.
EN
15
Publicidad
