Installation
Oven Assembly
NOTE: This appliance shall be installed in accor-
dance with current regulations and used
only in a well-ventilated space. Refer to the
instructions before installing and using
this appliance.
LEG ATTACHMENT
1. Attach each leg with two bolts to the bottom of
the oven.
Figure 1
OVEN STACKING (if applicable)
1. Place two boards on top of the lower oven.
2. Slide the upper oven on top of the boards.
3. Slide a board under the top oven. Lift up to re-
move the left board.
4. Slide the top section into position Remove the
right board.
Figure 2
81,2 cm Legs
OVEN DECKS
Ultra Rokite Decks
1. Slide the deck pieces into the unit until they
drop into the shelf supports.
2. Push together until the center gap closes. Use
only Blodgett Ultra Rokite decks.
Steel Decks
1. Slide the deck pieces into the unit until they
drop into the shelf supports.
2. Push together until the center gap closes.
3. Attach the retaining clip in the front of the
decks.
4. Attch the three deck clips in the rear of the
oven.
VENTILATION
1. Attach the back vent to each oven with the off-
set (enlarged) end toward the bottom.
4
Back Vent
Electrical Supply
Entrance
Figure 3