Blodgett Export Serie Manual De Instalación Y Operación página 9

CLEANING
WARNING!!
DO NOT spray the oven with a water jet.
Daily
1. Saturate a cloth with light oil. Wipe the oven
exterior when it is cold. Dry the oven with a
clean cloth.
2. Clean stainless surfaces with a non-toxic in-
dustrial stainless steel cleaner. Apply the
cleaner when the oven is cold, and always rub
with the grain of the metal.
3. Brush residue from beneath doors.
Weekly
1. Brush oven cavity, control area and cooling
fans.
REPLACEMENT OF PARTS
Removal of Oven Door
1. Open the oven door.
2. Remove the left corner trim panel and column.
3. Remove the two bolts in the left counter
weight.
4. Remove the retaining rings and door arms.
5. Remove the two bolts in the left hinge assem-
bly.
6. Remove the inner bolt on the right side of the
door. Loosen the outer bolts.
7. Slide the right hinge pin to the left. Note the
number of spacer washers used on the right
hinge pin.
8. Remove the door.
Control Panel Components
1. Shut off main power supply.
2. Pull the thermostat knob to remove.
3. Remove the bottom corner trim panel.
4. Remove one screw at the top of the control
panel. Remove panel.
5. Replace defective component. Reassemble
control panel.
Maintenance
Cleaning and Replacement of Parts
Upper Heater Assembly
1. Shut off the main power supply.
2. Open the control panel. Remove the screw
from the side cover. Remove the side cover.
3. Disconnect the three heater wires from the up-
per heater switch.
4. Cut the wire tie that holds the three heater as-
sembly wires to the upper heater assembly
cover box.
5. Open the oven door.
6. Disconnect the terminals inside the front ele-
ment terminal cover box. Remove the box.
7. Remove the L shaped element from the oven
compartment.
8. Remove the upper heater assembly retaining
bar.
9. Remove and replace the upper heater assem-
bly.
Lower Heater Assembly
1. Shut off the main power supply.
2. Open the control panel. Remove the screw
from the side cover. Remove the side cover.
3. Disconnect the three heater wires from the
lower heater switch.
4. Cut the wire tie that holds the three heater as-
sembly wires to the lower heater assembly
cover box.
5. Open the oven door.
6. Remove the decks.
7. Remove the right deflectors.
8. Remove the lower heater assembly retaining
bar.
9. Remove and replace the lower heater assem-
bly.
7