Mennekes AMTRON Compact 2.0 7,4 Manual De Instrucciones Y De Instalación página 37

Inside view
6
5
4
Fig. 4: Inside view
1 Cable glands *
2 Terminals
n 1 and 2: Enable input
n 3 and 4: Downgrade input
n 5 and 6: External shunt release switching
output
3 MCU (MENNEKES Control Unit)
4 DIP switch
5 Connection for the MENNEKES configuration
lead
6 Terminals for voltage supply
* Additional cable glands are installed on the top
and bottom.
3.5 LED information panel
The LED information panel shows the operating
status of the product (e.g. standby, fault).
Standby
1
2
3
Colour of the symbol: blue or green (dependent on
the configuration)
In Standby operating mode, the product can switch
to Sleep mode after 10 minutes to reduce internal
consumption. The Sleep mode is configurable and
is enabled in the delivery state. It is terminated by
plugging in the charging cable or by an authorisa-
tion. In Sleep mode, no symbol lights up on the LED
information panel.
Charging
Symbol Meaning
lights up The product is ready for use. No
vehicle is connected to the product.
flashes Not all requirements for charging are
slowly met, e.g.
n The authorisation process is com-
plete. No vehicle is connected to the
product.
n A vehicle is connected to the
product. There is a cause that pre-
vents or pauses the charging pro-
cess, e.g.
n The downgrade input is con-
figured to 0 A and currently act-
ive.
n The limit value for unbalanced
load was exceeded.
n The operating temperature was
exceeded.
flashes A vehicle is connected to the product.
rapidly Authorisation has not occurred.
Symbol Meaning
lights up The charging process is running.
EN
7