Names And Functions Of Indicators On Remote Controller - Qlima S42 Serie Instrucciones De Uso

RESET Button: When you press the recessed RESET button, all current settings are cancelled and the con-
k
trol will return to the initial settings.
Turbo Button / Active Clean button: Push this button on COOL mode, the air conditioner goes into
l
powerful cooling operation. Push again to cancel the TURBO function. Upon pressing this button (> 2
sec) the unit will go into the Active Clean mode. A complete process will be started to clean the internal
side of the evaporator and to reduce the breeding of bacteria. When this function is activated all timer
settings will be cancelled. To stop the Active Clean mode press the button (> 2 sec) again.
LOCK Button: When you press the recessed LOCK button, all current settings are locked in and the remote
m
controller does not accept any operation except that of the LOCK. Press again to cancel the LOCK mode.
LED DISPLAY / FOLLOW ME Button: Press this button to clear the digit display in the air conditioner. The
n
digit display in the air conditioner will reactivate itself automatically after 3 seconds, when no buttons are
being pressed in this period. Press it again to activate it (Not applicable to units without this function).
When pushing more than 2 seconds, the FOLLOW ME function will be activated, pushing more than 2
seconds again to disable.
Low sound button / indoor freezing prevention: Press this button to decrease the indoor sound pres-
o
sure level to 21 dB(A). The indoor unit fan speed is reduced to its lowest level. Upon pressing this button
(> 2 seconds) the unit will go into the freezing prevention mode. The unit will overrule the indoor tem-
perature setting and will set it to approx 8 °C. In this way preventing your home from freezing during
cold periods at the lowest possible energy consumption. When this mode is selected the indoor unit
display will show "FP". This button can only be operated in heating mode. To leave the Home Freezing
Prevention Mode: simply press the button once again.

Names and Functions of indicators on Remote Controller

auto cool dry heat
SET TEMP. TIMER ONOFF
sleep lock run
Transmission indicator: This transmission indicator lights when remote controller transmits signals to

the indoor unit.
Mode display: Displays the current opeartion mode. Including Auto

applicable to cooling only models), Fan
Temp. / Timer display: Displays the temperature setting (17º C ~ 30ºC). When you set the operating

mode to FAN, no temperature setting is displayed. And if in the TIMER mode, shows the ON and OFF
settings of the TIMER.
Fan speed display: Displays the selected fan speed, AUTO (no display), LOW

fan speed is AUTO when the operating mode is either AUTO or DRY.
ON / OFF display: Displayed by pressing the ON / OFF button. Press the ON / OFF button again to remove.

Lock display: Displayed when LOCK mode is activated.

Sleep display: Displayed under sleeping operation. Press the SLEEP button again to remove.

4
92
fan
2
1
3
4
7
6
5
.
, Cool , Dry , Heat
, MED and HIGH . The
(Not