Publicidad
Idiomas disponibles
Idiomas disponibles
Panel Mounting
Mount to panel using #8 or M4 screws. To install your controller using mounting
screws:
1. Remove the mounting template from inside the back cover of this document.
2. Secure the template to the mounting surface. (Make sure your controller is
spaced properly. See Controller Spacing on page 11.)
3. Drill holes through the template.
4. Remove the mounting
template.
5. Mount the controller.
6. Leave the protective debris
strip in place until you are
finished wiring the controller
and any other devices
Using the Battery
The MicroLogix 1100 controller is equipped with a replaceable battery. The Battery
Low indicator on the LCD display of the controller shows the status of the
replaceable battery. When the battery is low, the indicator is set (displayed as a
solid rectangle). This means that either the battery wire connector is disconnected,
or the battery may fail within 2 days if it is connected.
IMPORTANT
The MicroLogix 1100 controller ships with the battery wire
connector connected.
Ensure that the battery wire connector is inserted into the
connector port if your application needs battery power. For
example, when using a real-time clock (RTC), or to store the
program in the controller's memory for an extended period of
time while the power is removed.
Refer to the MicroLogix 1100 Programmable Controller User
Manual, publication 1763-UM001, for more information on
installation, handling, usage, storage, and disposal of the
battery.
MicroLogix™ 1100 Programmable Controllers
Mounting
Template
Publication 1763-IN001A-MU-P - May 2005
13
Publicidad
