Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting 1762 I/O Expansion Modules
ATTENTION
Connect 1762 I/O after mounting the controller.
1. Remove the expansion port cover to install expansion I/O modules.
2. Plug the ribbon cable connector into the bus connector.
3. Replace the cover as shown below.
The MicroLogix 1100 controller is designed to support up to any four 1762
expansion I/O modules.
For detailed information on using expansion I/O, refer to the installation
instructions for your expansion module.
Remove power to the system before installing or removing
expansion I/O or damage to the controller may result.
MicroLogix™ 1100 Programmable Controllers
Publication 1763-IN001A-MU-P - May 2005
15
Publicidad
