Extraordinary Maintenance - GGP ITALY 36 Manual De Instrucciones

16
EN
Chain maintenance table
WARNING!
are shown in the "EC Conformity Statement" provided. Do not use other types of chains or bars
for safety reasons.
The table gives the sharpening data for different types of chains, but this does not mean you
can use different chains from the homologated one.
Chain pitch
inches
3/8 Mini
0.325
3/8
0.404
BAR MAINTENANCE (Fig. 26)
To avoid asymmetrical wear on the bar, make sure
it is turned over periodically.
To keep the bar in perfect working order, proceed
as follows:
– grease the bearings on the nose sprocket (if
present) with the syringe;
– Clean the bar groove with the scraper (not in-
cluded);
– clean the lubrication holes;
– with a flat file, remove burr from the edges and
level off the guides.
Replace the bar whenever:
– the groove is not as deep as the height of the
drive links (which must never touch the bottom);
– the inside of the guide is worn enough to make
the chain lean to one side.

EXTRAORDINARY MAINTENANCE

All maintenance operations not foreseen in this
manual must be performed exclusively by your
dealer.
All and any operations performed in unauthorised
centres or by unqualified persons will totally inval-
idate the warranty.
The specifications of the chain and the bar homologated for this machine
Limiter tooth level (a)
mm inches
9.32 0.018
8.25 0.026
9.32 0.026
10.26 0.031
MAINTENANCE AND STORAGE
a
mm
0.45
0.65
0.65
0.80
STORAGE
After every work stint, clean the machine thor-
oughly to remove all dust and debris, and repair or
replace any faulty parts.
The machine must be stored in a dry place away
from the elements and with the bar cover correctly
fitted.
LONG PERIODS OF DISUSE
IMPORTANT
the machine for a period of more than 2-3 months,
we recommend you do a few things before putting
it away. This will make it easier when you want to
use the machine again and will also prevent per-
manent damage to the engine.
• Storage
Before putting the machine away:
– Unscrew the two nuts, remove the guard and re-
move the chain and rod.
– Empty the oil tank, fill with about 100-120 cc of
specific liquid detergent and plug the cap.
– Fit the guard back on without tightening the nuts.
– Start the engine and keep it running until all de-
tergent is used.
– Start the engine and run it idle until it uses up all
File diameter (d)
d
inches mm
5/32 4.0
3/16 4.8
13/64 5.2
7/32 5.6
If you are not going to use