Stanley STST1825 Manual De Instrucciones página 32

Idiomas disponibles

32 • ENGLISH

Step 2

Repeat Step 1 so that there are two frames assembled.

Step 3

Select the following parts:

2 x Part 2

2 x Part 4

These will form the crosspieces between the

previously assembled frames. Lay the parts flat on

the floor. Connect the longer Part (2) and fix it to the

frame in the center of the uprights. Note that Part

2 should be positioned as shown in Fig. B4. Connect

Part 4 (top cross support) to the top of the frame. Note

that Part 4 should be positioned as shown in Fig. B4.

Step 4

Now place and connect the ends of the top and center

frame supports to the frame. Take care to ensure that

the supports are positioned as shown in Fig. B5.

Step 5

Once you are satisfied that the frame is assembled

correctly, fully tighten ALL the bolts.

Finally, assemble the 4 foot pads to the bottom of

each leg (see Fig. B6).

Fitting the table saw to the stand (see FIG. C1, C2)

There are four mounting holes on the base of the saw.

4 corresponding mounting holes are located on the top

plane of the stand. Put the table saw on the stand, match

the holes on the base of the saw with the holes on the

stand, and secure them with the 4 bolts (b) provided. DO

fully fasten.