Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the Hang-Up Clip
Once an installation location has been
decided, perform the following steps:
1. Verify that the selected mounting
surface is strong enough to support
the mounting hardware and the
microphone.
2. Use the base of the hang-up clip as a
template to center punch and drill two
3mm (1/8") diameter holes. Be careful
not to damage any wires or any other
vehicle components when drilling the
holes.
3. Use the two self tapping screws
provided to mount and secure the
hang-up clip.
Making Final Connections
When the hang-up clip is installed and
secured:
1. Snap the microphone into the hang-
up clip.
2. Connect the microphone's coiled cord
plug to the microphone connector on
the front of the radio. Align the
connector pins then twist outer collar
clockwise to lock in place.
4
Publicidad
