Publicidad
Idiomas disponibles
Idiomas disponibles
CHAPTER -3: USING YOUR FRIDGE FREEZER
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance,
it is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal build up
of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded appliance, high
room temperature, frequent door openings), put the temperature setting device on a lower position until compressor
off periods are obtained again.
Store food in the coldest area of the refrigerator.
Your foods will be better stored if you put them in the most appropriate
cooling area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To be sure to have a low temperature in this area, make sure the shelf is
located at the level of this symbol, as shown in the illustration.
The upper limit of the coldest area is indicated by the lower side of the sticker (head of
the arrow). The coldest area upper shelf must be at the same level with the arrow head.
The coldest area is below this level.
As these shelves are removable, make sure they are always at the same level with these
zone limits described on the stickers, in order to guarantee temperatures in this area.
Use of VacPac Pro
1. The food to be kept is placed on one side embossed vacuum bag.
2. The opening of the vacuum bag should be held tightly from either side as shown in the figure 1 and inserted into
the compartment in the indicator it should be inserted by 5 cm, up to the red strip on the bag.
3. Press start button on the display. (Figure 2)
EN -10-
Publicidad
