Publicidad
Idiomas disponibles
Idiomas disponibles
Lamp adjustment
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "A, B, C" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.
Inserting/Exchanging gobos
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
Install the gobos with the device switched off only.
Unplug from mains before!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
Slot-in gobo-system for exchanging gobos without tools!
Inserting/Exchanging gobos as described above.
The lampholder is aligned at the factory. Due to differences
between
lamps,
fine
performance.
Strike the lamp, open the shutter, set the dimmer intensity
onto 100 % and direct the light towards a flat surface (wall).
Center the hot-spot (the brightest part of the beam) using the
3 adjustment screws "A, B, C". Turn one screw at a time to
drag the hot-spot diagonally across the projected image. If
you cannot detect a hot-spot, adjust the lamp until the light is
even.
To reduce a hot-spot, pull the lamp in by turning all three
screws "A, B, C" clockwise ¼-turn at a time until the light is
evenly distributed.
DANGER!
CAUTION!
Notes!
37/104
adjustment
may
improve
51837570_V_1_0.DOC
light
Publicidad
