Husqvarna WS 482 HF Manual De Usuario página 14

1. Disconnect the power cord between the saw unit and
the power pack. Assemble the lids on the plug
connectors.
2. Disconnect the water hoses from the saw unit.
3. Disassemble the blade guard.
4. Remove the blade guard guide.
5. Disassemble the blade. Disassemble the outer blade
flange, the blade and the blade bolt.
Introduction
WARNING:
safety chapter before you use the product.
To adjust the blade guard guide
1. Loosen the nuts on the 2 adjustable guide wheels.
2. Attach the blade guard guide to the blade guard.
3. Turn the camshafts with a 22 mm wrench until the
guide wheels touch the rail.
4. Hold the camshaft in position with a 22 mm wrench
and tighten the nut with a 16 mm wrench.
5. Make sure that the wheels turn easily and that there
is no play in the blade guard guide.
To adjust the lock handle on the blade
guard guide
1. Attach the blade guard guide to the saw unit.
2. Loosen the 2 stop screws with a 3 mm hex key.
1675 - 001 - 11.06.2021
Operation
Read and understand the
6. Push down the lock buttons and fold out the lock
handles to release the saw unit from the rail.
7. Release the carriage bolts of the clamp washer on
the wall supports and lift the rail off the supports.
Release 1 of the eccentric bolts in the middle of the
rail to disconnect the rails. Remove the rails.
8. Disassemble the wall supports.
3. Turn the camshaft with a screwdriver until the lock
handle tightens around the blade guard bracket.
4. Tighten the 2 stop screws with a 3 mm hex key.
5. Remove the 4 screws that hold the snap lock in
position with a 4 mm hex key.
6. Adjust the snap lock. The snap lock must tighten
around the top rail.
7. Tighten the 4 screws that hold the snap lock in
position with a 4 mm hex key.
To adjust the guide wheels
1. Loosen the 2 M10 screws with an 8 mm hex key (A).
2. Loosen the 2 stop screws that lock the 2 guide
wheels with a 3 mm hex key (B).
3. Turn the shafts carefully with a 16 mm wrench until
the guide wheels touch the rail (C).
A
A
B
C
C
B
13