Husqvarna WS 482 HF Manual De Usuario página 21

Symptom
The blade does not
cut and starts to pol-
ish the diamond
blades.
Transportation
• If your product has a transport trolley, use it to move
the product. The handles of the transportation trolley
can be used as runners when you lift it on to a truck.
• Stop the power pack and pull out the electric cable
before you move the equipment.
• Remove the blade and blade guard from the product
before the transportation.
Storage
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Remove the blade and blade guard from the product
after the operation.
• If there is a risk that the water will freeze, the product
must be drained of all remaining water coolant.
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
Technical data
Weight
Saw carriage, kg/lbs
Saw unit, kg/lbs
Blade guard 800 mm, kg/lbs
Blade guard 1000 mm, kg/lbs
Track 1200 mm (47 in.) kg/lbs
Track 2000 mm (79 in.) kg/lbs
20
Troubleshooting
Cause
The cutting depth is too large.
The blade speed is too high.
The water flow to the blade is too high.
The blade is too hard.
Transportation, storage and disposal
Technical data
Solution
Decrease the cutting depth.
Decrease the blade speed.
Decrease the water flow to the blade.
Change the blade to a softer blade.
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
3.7/8.2
28/59.5
13/28.7
16/35.3
9.5/20.9
19/41.9
1675 - 001 - 11.06.2021