Husqvarna WS 482 HF Manual De Usuario página 13

To attach the blade guard
WARNING:
from the power supply before you start the
assembly.
1. Put the blade guard guide between the rods on the
blade guard.
2. Lock the plastic heel on the handle to the top rod on
the blade guard.
3. Make sure that the cutting arm is vertical. Lift the
blade guard above the blade and hang the guard in
the blade guard holder on the product. Make sure
the runners on the blade guard are installed in the
slots on the water unit.
4. Pull the handle out of the blade guard and down
against the saw unit. The fastener locks the handle.
12
Disconnect the product
5. To remove the blade guard, release the fastener and
pull the handle up and against the blade guard. Lock
the plastic heel on the top rod on the blade guard.
6. Connect the water hose from the outlet on the saw
motor to the inlet on the blade flange hub.
To connect the power pack
CAUTION:
an approved Husqvarna power pack.
1. Connect the water hose from the power pack to the
water inlet on the saw unit (A).
2. Connect the power cord from the power pack to the
saw unit (B).
3. Start the power pack and start the remote control.
4. Make sure that the remote control is connected to
the power pack through radio transmission. Refer to
the operator's manual for the Husqvarna power pack
for information about the remote control.
To disassemble the product
If the product has a transport trolley, put all
disassembled parts on the transport trolley.
Only use the product with
B
A
1675 - 001 - 11.06.2021