Husqvarna WS 482 HF Manual De Usuario página 18

• Push the ON/OFF button to start and stop the
remote control.
• Longitudinal movement: The dial moves the product
along the rail.
• Arm movement: The dial moves the pivot arm to
adjust the cutting depth.
• To rotate the blade and to control the speed of the
product: Push and hold the return button while you
turn the dial clockwise to increase the rotation speed
of the blade.
1675 - 001 - 11.06.2021
OK
ON/OFF
0
OK
ON/OFF
0
OK
ON/OFF
0
OK
ON/OFF
0
• To stop the product: Turn the dial that controls the
rotation speed of the blade counterclockwise to its 0
position.
• If an emergency occurs, stop the product with the
stop button.
• Refer to the Husqvarna power pack manual for other
settings and functions of the remote control.
To operate the product
1. Start the product. Refer to
page 15 .
2. Control the product with the remote control. Refer to
To operate the remote control on page 16 .
3. Do a guide cut to a depth of 3-7 cm/1.2-2.8 in (A).
The material and available fuses have an effect on
the cutting depth. If it is possible, do not cut into iron.
Do the guide cut with the arm in trailing position.
CAUTION:
the guide cut.
4. Increase the depth for the subsequent cuts (B). Put
the saw near a mounting bracket and push the blade
into the material. The depth of the subsequent cuts
are between 7-15 cm/2.8-5.9 in. The hardness of the
material has an effect on the cutting depth.
OK
ON/OFF
0
To start the product on
A
Do not use full power for
B
17