Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
7.3
ASSEMBLE THE GUIDE BAR AND
THE CHAIN
1. Switch off the machine and remove the battery.
2. Loosen the chain cover by turning the bar nut (8)
counterclockwise.
3. Remove the chain cover (14).
4. Put the chain drive links (17) into the bar groove
(15).
5. Put the chain cutters (16) in the direction of the
chain operation.
6. Ensure the chain is put on in the correct direction
(do not assemble with the cutters backwards).
IMPORTANT
English
7. Put the chain in position and make sure that the
loop is behind the guide bar.
8. Hold the chain and bar.
9. Put the chain loop around the sprocket (18).
10. Make sure the chain tension pin hole (19) on the
guide bar fits correctly with the bolt.
11. Install the chain cover.
12. Tighten the chain. Refer to Adjust the chain tension.
13. Tighten the bar nut when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after the
first use, examine the tension and tighten the chain if
necessary.
8
NOTE
Publicidad
