Publicidad
Idiomas disponibles
Idiomas disponibles
7.4
FIT THE POLE SAW
1. Connect polesaw head to polesaw handle.
2. Slide the collar upwards.
3. Turn the collar clockwise to tighten.
7.5
EXTENSION OF THE POLE SAW
1. Fit the extension pole between the pole saw handle
and the pole saw head to achieve the maximum
length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
WARNING
Periodically check the tightness of the connection
of the collars.
7.6
CUTTING PREPARATION
Before you start to cut, make sure that
•
Wear heavy gloves for maximum grip and
protection.
•
Maintain a proper grip on the machine during
operation.
•
Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
•
Keep your body to the left of the chain line.
•
Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
•
Never stand directly under the limb you are cutting.
•
Periodically examine the tightness of the collars
during operation.
English
7.7
INSTALL THE BATTERY PACK
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.8
REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
8
OPERATION
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
Examine the chain tension before each use.
8.1
EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add oil if necessary.
9
WARNING
NOTE
IMPORTANT
NOTE
EN
Publicidad
