Solter aeroprocess 4200 DV Manual De Instrucciones página 47

P.27 -
P.28 7
P.29 65
P.30 -
P.31 -
P.32 -
P.33 -
P.34 -
P.35 3
P.36 Nor
P.37 -
P.38 -
P.39 -
P.40 -
P.41 -
P.42 -
-
P.43
-
P.44
-
P.45
P.46 1
P.47 0
P.48 -
P.49 -
P.50 -
P.51 -
P.52 -
P.53 -
P.54 -
P.55 -
P.56 -
P.57 50
P.58 125%
P.59 5
P.60 12
SOLTER
SOLDADURA S.L.
Not available in this model.
Arc-force sensitivity for coated electrodes.
It allows adjustment of sensitivity to activate the arc-force mode. A high value delays
the activation of this feature. Lower values improve the transfer of material for alumi-
nium or stainless steel-coated electrodes.
Amperage preheating during TIG contact ignition.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Coolant circulation time at the end of a weld, in 10-second intervals.
Mode of operation of the cooling unit.
It is recommended to have the automatic mode selected at all times.
Nor - Automatic mode (recommended).
For - Forced mode. This can be used for a short period of less than 2 minutes to faci-
litate the task of priming the coolant circuit.
dis–Disabled mode. Select this mode if an uncooled torch is going to be used. Re-
member to enable the automatic mode again when finish. DO NOT disable the cooler
if you are using a cooled torch as this could damage the torch.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
1 is recommended to manage bead penetration depending on the energy of the arc,
or 0 to manage penetration depending on the amperage.
If enabled, it allows the penetration control a greater arc height variation. It is recom-
mended to keep it disabled to minimize welding defects.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Speed of wire threading under local control in 0.1m/min.
Speed ratio between the winder motor and the torch motor.
Assistance supervision setting for MIG Arc-force in the event of disturbances.
Wire feed speed before starting the arc at 0.1m / min.
AEROPROCESS 20