Transport And Installation Of The Welding Machine; Description Of The Items Of Equipment - Solter aeroprocess 4200 DV Manual De Instrucciones

If the nominal operating cycle of the machine is exceeded and the equipment is forced to work for too
long without being allowed to cool properly, this could cause significant damage not covered by the
NO-LOAD VOLTAGE REDUCTION SYSTEM
Optionally, the machine can be supplied with the VRD (voltage reduction device) feature pre-activated. If this feature
is activated, the no-load voltage does not exceed 15VDC, providing a higher level of safety. For safety reasons, this
feature can not be manipulated by the operator. Consult your dealer to enable or disable this feature.

TRANSPORT AND INSTALLATION OF THE WELDING MACHINE

Impacts should be avoided during transport of the machine. The transport position must be as indicated on the pac-
kaging. The machine must be located in a dry, well-ventilated area, away from the welding station, to prevent metal
dust entering the welding machine. The machine must be installed on a horizontal surface with a maximum gradient
of 10°. Place the machine away from water outlets. The machine must be connected to an electrical box, which
should consist of a circuit breaker and an automatic switch. The circuit breaker protects people from direct or indirect
contact with electrical parts. The automatic switch must be chosen according to the equipment nameplate. A switch
with an intensity/time ratio of the slow type (D curve) is recommended to prevent false triggering.
HANDLING OF THE MACHINE
To handle the power unit always use the front and rear handles. If you have the UTS 200 transport unit, check that all
couplings are properly fixed. To handle the machine once it is located in the transport unit, DO NOT use the upper
handles of the power unit. Handle the whole machine using eye bolts screwed to the base of the transport unit.

DESCRIPTION OF THE ITEMS OF EQUIPMENT

1 - Control panel
2 - Positive pole connector
3 - Gas connector
4 - Aerofeed input connector
5 - TIG torch conector or remot control in MMA mode.
6 - Negative pole connector
SOLTER
SOLDADURA S.L.
ATTENTION
guarantee.
7 - Main switch
8 - Connection to three-phase power network
9 - 2A fuse (control)
10 - 2A fuse (motor)
11 - USB connector
12 - Gas input
AEROPROCESS 5