Operating The Front Panel - Solter aeroprocess 4200 DV Manual De Instrucciones

OPERATING THE FRONT PANEL

A - Welding type selector. This button lets you choose between the different types of welding offered by the machine.
The selector is sequential, so each time the button is pressed, a new type of welding is selected.
Possible options:
B - Material and wire diameter selectors. Only available in MIG mode. This buttons let you select between different
material options. See the sticker on the inside of the winder for details. When you change material or diameter, the
SYN mode is always activated by default.
C - Synergic(automatic) mode or manual mode selector. For optimum welding quality you are recommended to select
the synergic mode. In this mode, the welding voltage is always right for the speed you select, allowing a minor adjus-
tment to the arc height parameter. In MANUAL mode, you can adjust the welding voltage and speed independently.
ATTENTION
In MANUAL mode, the machine could be set in a non proper way.
D - Main panel displays. These displays show all the values selected: welding variables, menu options, and the cu-
rrent and voltage values of the welding process.
E - Main selector. With this selector you can select menu options and set the values of the different parameters. The
value that can be modified always appears in flashing mode.
F - Menu button. With this button you can enter and exit the advanced parameter setting menu.To move or change a
menu option, use the selector E.
G - Button to activate the remote control from the winder or other accessory.
H - Machine status indicator. This part displays several indications: machine operating, cooler unit running, remote
control and anomalies.
SOLTER
AEROPROCESS 9
SOLDADURA S.L.