1- Safety information
1- Safety informatio n
Before switching on the appliance for the first time read the following
safety hints!:
WARNING!
Before first use
Make sure there is no transport damage.
Remove all packaging and keep out of children's reach.
Wait at least two hours before installing the appliance in order to
ensure the refrigerant circuit is fully efficient.
Handle the appliance always with at least two persons because it is
heavy.
Installation
The appliance should be placed in a well-ventilated place. Ensure a
space of at least 10 cm above and 10 cm around the appliance.
Never place the appliance in a damp area or location where it might
be splashed with water. Clean and dry water splashes and stains with
a soft clean cloth.
Do not install the appliance in direct sunlight or in the near of heat
sources(e.g. stoves, heaters).
Install and level the appliance in an area suitable for its size and use.
Keep ventilation openings in the appliance or in the in-built structure
clear of obstruction.
Make sure that the electrical information on the rating plate agrees
with the power supply. If it does not, contact an electrician,
The appliance is operated by a 220-240 VAC/50 Hz power supply.
Abnormal voltage fluctuation may cause the appliance to fail to start,
or damage to the temperature control or compressor, or there may
be an abnormal noise when operating. In such case, an automatic
regulator shall be mounted.
Use a separate earthed socket for the power supply which is easy
accessible. The appliance must be earthed.
Only for UK: The appliance's power cable is fitted with 3-cord
(grounding) plug that fits a standard 3-cord (grounded) socket.
Never cut off or dismount the third pin (grounding). After the
appliance is installed, the plug should be accessible.
Do not use multi-plug adapters and extension cables.
Ensure that the power cable is not trapped by the refrigerator. Do not
step on the power cable.
Do not damage the refrigerant circuit.
4
GB