Zanussi ZWT 71401 WA Manual De Instrucciones página 18

Ocultar thumbs Ver también para ZWT 71401 WA:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note!
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning phase
may result in partial dryness. In the excep-
tional case that at the end of the cycle the
laundry remains slightly wet, we suggest
that you unfold the rolled up items, redis-
tribute them evenly in the drum and select
an additional drying cycle of 20-30 mi-
nutes.
6. At the end of the programme, the buzzer
sounds and three blinking «0.00» appear on
the display and the pilot light 9is on to indi-
cate that the door is locked.
The last 10 minutes of the drying cycle cor-
respond to an anti-crease phase. During
this time the door is locked and the display
keeps showing three flashing zeros «0.00».
If you wish to open the door before or dur-
ing the anti-crease phase or to interrupt it,
press any button or turn the programme selec-
tor dial to any programme position (except O).
7. Turn the selector dial to the O position to
switch the machine off.
8. Remove the laundry.
Automatic washing and drying (NON-
STOP programme)
For NON-STOP programmes, the recommen-
ded load size is 3 kg for cotton and 1,5 kg for
synthetic.
It is possible to dry up to 4 kg of cotton
items by pressing Drying Time button only
(see the «Drying Programme » table).
Caution! Do not use a dosing device/
ball when carrying out a washing and
drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the se-
lector dial to the selected washing pro-
gramme/fabric.
18
4. Select the required options by pressing the
relevant buttons.
If possible, do not select a spin speed lower
than that proposed by the appliance to avoid
too long a drying time therefore saving energy.
In any case the reduction of the spin speed
is only possible after selecting drying.
5. Select the drying time by pressing button 5.
The display shows the entire duration of the
washing and the selected drying cycle.
6. Start the programme by pressing button 8.
After the programme has started, the time
remaining is updated every minute.
7. At the end of the programme turn the se-
lector dial to the O position to switch the
machine off.
8. Remove the laundry.
Fluff in the garments
During the WASHING AND/OR DRYING
PHASE, certain types of fabric, as sponge-
cloth, wool, sweatshirt, could release fluff.
The released fluff could stick to the fabrics dur-
ing the next cycle.
This drawback increases with technical fabrics.
To prevent the lint in your clothes, it is recom-
mended:
• To do not wash dark fabrics after you washed
and dried light colored fabrics (new sponge,
wool, sweatshirt especially) and vice versa.
• To air-dry this type of fabrics when they are
washed the first time.
• To clean the filter.
• Perform one or more rinse cycles to wash the
drum between the washing and drying of fab-
rics with different colors.
• After the drying phase, thoroughly clean the
empty drum, the gasket and the door with a
wet rag.
www.zanussi.com

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido