Zanussi ZWT 71401 WA Manual De Instrucciones página 26

Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and stable.
If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Caution! Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.
After having levelled the appliance, tighten the
lock nuts.
26
Water inlet
An inlet hose is supplied and can been found in-
side the machine drum. Do not use the hose
from your previous machine to connect to the
water supply.
This appliance must be connected to
a cold water supply.
1. Connect the hose with the angled connec-
tion to the machine.
2. Do not place the inlet hose downwards.
Angle the hose to the left or right depend-
ing on the position of your water tap.
35°
3. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
4. Connect the hose to a tap with a 3/4"
thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways.
• Hooked over the edge of a sink using the
plastic hose guide supplied with the machine.
45°
www.zanussi.com