Sigma EF-530 DG SUPER Manual De Instrucciones página 15

DESCRIPTION OF THE PARTS
EXTERNAL PARTS
1.Flash Head 2.Built-in Wide Panel
5.Bounce Angle; Right and Left
7.Swivel Lock and Release Button; Right and Left
11.Shoe
CONTROLS
12.MODE Button 13.<SEL> SELECT Button
16.ZOOM Button 17.TEST Button
CAMERA MODELS AND FUNCTIONS
This flash can be used with cameras, which are given below.
D2 Series, D200, D80, D70s, D70, D50, D40X, D40, D1 Series, D100,
F6, F5, F4 Series, F3 Series(*), F100, F90X/N90S Series, F90/N90 Series, F80 Series, F75/N75,
F70D/N70, U/F65/N65, F60D/N60, F55/N55, F50D/N50, F-801S/N8008S, F-801/N8008, F601M,
F-601/N6006, F501/N2020, F401X, F401S/N4004S, F-401/N4004, F-301, N2000, FA, FE10, FE-2,
FG, FM10, New FM2, FM3, Nikonos V(*), Pronea 600i
This instruction book is used for the following lens types. (Please check your lens.)
With Built-in CPU Nikon Lenses
Without Built-in CPU Nikon Lenses
ABOUT THE BATTERY
This flash unit uses four "AA" type Alkaline dry cell batteries or Ni-Cad, Ni-MH rechargeable batteries.
Manganese batteries can also be used but as they have a shorter life than Alkaline batteries, we do not
recommend using them. Please replace batteries if it takes more than 30seconds to light the Ready Lamp.
◆ To assure proper electrical contact, clean the battery terminals before installing the batteries.
◆ NiCad batteries do not have standardized contacts. If you use NiCad batteries, please confirm that the battery
contacts touch the battery compartment properly.
◆ To prevent battery explosion, leakage or overheating, use four new AA batteries of the same type and brand.
Do not mix the type or new and used batteries.
◆ Do not disassemble or short-circuit the batteries, or expose them fire or water; they may explode. Do not
recharge the batteries other than Ni-Cd or Ni-MH rechargeable batteries.
◆ When the flash will not be used for an extended period of time, remove the batteries from the flash to avoid
the possibility of damage from leakage.
◆ Battery performance decreases at low temperatures. Keep batteries insulated when using the flash in cold weather.
◆ As with any flash, it is recommended you carry spare batteries when on a long trip or when photographing
outdoors in cold weather.
BATTERY LOADING
1. Be sure to set the Power Switch to the off position then
slide the battery cover in the direction of the arrow to
open.
2. Insert four AA size batteries into the battery chamber. Be
sure the + and – ends of the batteries are aligned
according to the diagram in the chamber.
3. Close the cover.
4. Slide the Power Switch to the ON position. After few
seconds the Ready Lamp will light, indicating that the
flash unit can be fired.
5. Please press the "Test Button" to be sure that the flash is
working properly.
3.AF Auxiliary Light
6.Bounce Lock and Release Button; Up and Down
8.LCD Panel
14.< + > Increment Button
18.LIGHT Button
D Type Lenses, G Type Lenses, IX Nikor Lenses, Except D type AF
lens (does not include F3AF), Ai-P type lens
Ai-S, Ai, Series E lens
4.Bounce Angle; Up and Down
9.Battery Cover
15.< - > Decrement Button
19.Ready Light 20.Power Switch
(*) It is necessary to use adapter for connection.
10.Shoe Ring
14