dBTechnologies INGENIA IG2T Manual Del Usuario página 52

3. CONTROL PANEL AND SETTING MENUS
ACCESSING THE MENUS
The push rotary encoder (3) allows the user both to perform a selection by turning it and to confirm a selection by
pressing it. These operations allow to navigate the menus and sub-menus available on the OLED display (2). Inside
the menus and sub-menus, turning the encoder to the right or to the left also allows to increase or decrease the
selected values.
The initial screen at switch-off displays the IG2T level and gain. All settings can be protected by a password.
• Once manually performed, the settings remain stored even after the speaker has
been switched off.
• After approximately one minute has elapsed since the last selection or
confirmation, the system returns to the initial screen (IG2T level/gain). The user
can also return to the initial screen from any point, in 2 ways:
a.
b.
• If the speakers are 2, correctly stacked, the system recognizes them, and you can
control both of them using the rotary of one of them (mirroring OLED).
At switch-on, the IG2T display shows the initial screen, indicating the GAIN and the signal level,
simulating a VU METER.
INGENIA IG2T
52
CONFIRM
by selecting and confirming, when existing in a sub-menu, the symbol
by holding the push rotary encoder pressed for a few seconds
SELECT / DECREASE
Push rotary encoder use examples
English
SELECT / INCREASE
Cod. 420120238 REV. 1.1