Descargar Imprimir esta página

Honda WMP20X1E Manual Del Propietário página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
NOTICE
Pumping liquids that are not listed may cause damage to the pump.
Agricultural Chemicals
Aatrex
Dual
Amiben
Eradicane
Ammonium
Extrazine
Thiosulfate
Banvel
Larsban
Basagran
Lasso
Bicep
URAN Solutions
Bladex
Modown
Industrial Chemicals
Acetic Acid, 20%
Glycerine (Glycerol)
Aluminum Sulfate
Lactic Acid
Ammonium Nitrate
Lead Acetate
Ammonium Sulfate
Magnesium Chloride Sodium Bisulfite
Barium Sulfate
Magnesium Nitrate
Borax (Sodium
Magnesium Sulfate
Borate)
* Calcium Chloride
Maleic Acid
Citric Acid
Nickel Chloride
Copper Sulfate
Nickel Sulfate
Detergents
Oleic Acid
(General)
Ethylene Glycol
Phosphoric Acid,
0-80%
Fatty Acids
Potassium
Carbonate
Ferric Nitrate
Potassium Chloride
Ferric Sulfate
Potassium Nitrate
Ferrous Sulfate
Potassium Sulfate
Formaldehyde,
Soaps (neutral)
40%
* Temperature does not exceed 26°C.
The temperature operating range of the pump is between
-7 ~ 54°C.
6
PUMP PERFORMANCE
The maximum pump discharge capacity is determined when pumping
clear water at 0 meters total head and at sea level. As the total head
[1] (discharge head [2] + suction head [3]) increases, pump discharge
capacity decreases (see figure). If the pump is used at higher
N-Serve 24
elevations, pump discharge capacity may also decrease. Other
factors affecting pump discharge capacity are:
Phosphoric Acid
Solutions
• The type of chemical being pumped.
Poly-N
• The length and type of the suction and discharge hose used.
Ranger
Round-up
Sutan
Treflan
Vernam
Sodium Acetate
Sodium Bicarbonate
Sodium Bisulfate
Sodium Carbonate,
10%
Sodium Chlorate
Sodium Chloride
Sodium Nitrate
Sodium Silicate
Sodium Sulfate
Oil Alert® System
The Oil Alert system is designed to prevent engine damage caused by
Stearic Acid
an insufficient amount of oil in the crankcase. Before the oil level in
the crankcase can fall below a safe limit, the Oil Alert system will
Sulfuric Acid, 0-29%
automatically shut down the engine (the ignition switch will remain in
the ON position).
Tartaric Acid
If the engine stops and will not restart, check the oil level (page 9)
before troubleshooting in other areas.
Vinegar
Water (Clear)
Water (Salt)
Zinc Sulfate
ENGLISH
[2]
[3]
Pump Performance (Maximum with clear water)
Total head [1]
Suction head [3]
Discharge capacity
Self-priming time
Pressure
[1]
32 m
8 m
833 /min
65 sec at 5 m
310 kPa

Publicidad

loading