GreenWorks Pro CS60L02 Manual Del Operador página 12

EN
Tension the chain so that it can only just be pulled away from
the bar at its centre point.
A slack chain may jump off and cause serious or even fatal
injury.
Wear protective gloves if you touch the chain, bar or areas
around the chain.
1. Stop the machine.
2. Loosen the lock nuts with the wrench.
It is not necessary to remove the chain cover to adjust the
chain tension.
3. Turn the chain adjustment screw clockwise to increase
the chain tension.
4. Turn the chain adjustment screw counterclockwise to
decrease the chain tension.
5. When the chain is at the wanted tension, tighten the lock
nuts.
During normal saw operation, the temperature of the chain
increases. The drive links of a correctly tensioned warm
chain will hang approximately 1/16 in. (1.58 mm) out of the
bar groove.
1/16 in. (1.58 mm)
WARNING
CAUTION
NOTE
NOTE
English
11.3 SHARPEN THE CUTTERS
Sharpen the cutters if it is not easy for the chain to go into the
wood.
We recommend that a service center, which has an electric
sharpener, perform important sharpening work.
1. Tensioning chain.
2. Sharpen the cutters corner with a 5/32 in. (4 mm)
diameter round file .
3. Sharpen the top plate, side plate and depth gauge with a
flat file.
4. File all the cutters to the specified angles and the same
length.
12
NOTE