WARNING
Periodically check the tightness of the connection of the
collars.
7.6
USE THE SHOULDER STRAP
60°MAXIMUM
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
7.7
CUTTING PREPARATION
Before you start to cut, make sure that
•
Wear heavy gloves for maximum grip and protection.
•
Maintain a proper grip on the machine during operation.
•
Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
•
Keep your body to the left of the chain line.
•
Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
•
Never stand directly under the limb you are cutting.
•
Periodically examine the tightness of the collars during
operation.
7.8
INSTALL THE BATTERY PACK
English
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.9
REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
8
OPERATION
Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
Examine the chain tension before each use.
8.1
EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add oil if necessary.
8.2
START THE MACHINE
1. Install the battery pack into the machine.
2. Pull the lock-out button (1) upward.
3. Press the trigger (2).
9
WARNING
NOTE
IMPORTANT
NOTE
EN