Publicidad
Idiomas disponibles
Idiomas disponibles
Always start the saw and allow it to reach full speed
before plunging into work material.
a) ALWAYS use your saw with your hands positioned
correctly.
WARNING: Always maintain proper control
of the saw to make sawing safer and easier.
Loss of control of the saw could cause an accident
resulting in possible serious injury.
b) When making cross or rip cuts, align your line of
cut with the center of the "V" notch located on the
front of the saw's base.
c) Since the thickness of blades varies, make a trial
cut in scrap material along the guideline to determine
how much, if any, you should offset the blade from
the guideline to allow for the blade thickness to get
an accurate cut.
MAKING RIP CUTS
Always use a guide when making long rip cuts with
your saw. You can use any suitable straight edge
clamped to the work or the parallel guide that is
included with your saw.
2. POCKET CUTTING (SOFT MATERIALS ONLY)
(See Fig. E1, E2, E3)
This operation requires much skill with a saw and
must only be carried out by a qualified person.
WARNING: The blade teeth are exposed during
this operation so proceed with extreme caution.
Clearly mark the area to be cut. Set the depth of cut
on the saw. Position the saw over the marked area
with the front edge of the base plate resting on the
work surface and cutting guide aligned with marked
line on workpiece.
Ensure the blade is not touching but is close to the
work surface. The moving lower guard must be
rotated open by using lever. Switch the saw on and
gently swing the blade down into the material but
maintain a pivoting force on the front edge of the
base. The moving lower guard can now be released
for normal action of the guard.
DO NOT bind the blade in the cut; push the saw
blade forward at a rate where the blade is not
laboring.
When the cut is complete, release the trigger safety
release and switch and let the blade come to a
complete stop. DO NOT REMOVE the saw and
blade from the workpiece while the blade is moving.
This could damage your cut (kerf), cause kickback and
loss of control, resulting in injury.
WARNING: To avoid cutting injury from the
sharp blade, please don't put your hands around
the base plate.
Using the laser light feature (See Fig. F)
NOTE: Clean the laser generator periodically.
WARNING: Never stare directly into the laser
beam and never point the beam at anybody. The
laser beam energy is extremely harmful to human
eyes.
WARNING: When not in use, always turn the
laser off to save the battery capacity.
Compact Circular Saw
Replacing laser batteries (See Fig. G1-G3)
To fit new batteries, adjust the position of the cord
and insert two batteries in place. Make sure two
batteries are pressed on the cord. To remove the
batteries, just slowly pull the end of the cord.
NOTE: Pay attention that "+/-" of the batteries are the
same as the illustration on the machine.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base
to ensure proper performance.
15
EN
Publicidad
