Publicidad
Idiomas disponibles
Idiomas disponibles
the wheel from the cut while the wheel is
in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate
the cause of wheel binding.
h) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power tool is
restarted in the workpiece.
i)
Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
j)
Use extra caution when making a "pocket
cut" into existing walls or other blind
areas. The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
ADDITIONAL SAFETY
RULES:
1. Always wear a dust mask.
SAFETY WARNING FOR
YOUR LASER
Warning for class II laser
CAUTION--Laser radiation when open. DO NOT STARE
INTO BEAM
CAUTION--Laser radiation when open and interlock
defeated. DO NOT STARE INTO BEAM
LASER RADIATION--DO NOT STARE INTO BEAM
ADDITIONAL SAFETY
WARNING
Do not stare directly at the laser beam. A hazard may
exist if you deliberately stare into the beam, please
observe all safety rules as follows:
1.
The laser shall be used and maintained in
accordance with the manufacturer's instructions.
2.
Never aim the beam at any person or an object
other than the work piece.
3.
Always ensure the laser beam is aimed at a
sturdy work piece without reflective surfaces,
e.g. wood or rough-coated surfaces are
acceptable. Bright shiny reflective sheet steel or
similar is not suitable for laser applications as
the reflective surface may direct the laser beam
back at the operator.
4.
Do not change the laser device with a different
type. The manufacturer or an authorized agent
must carry out repairs.
5.
CAUTION: Use of controls or adjustments
other than those specified herein may result in
Compact Circular Saw
hazardous radiation exposure.
6.
CAUTION--The use of optical instruments with
this product will increase eye hazard.
SAVE THESE INSTRUCTIONS
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Do not stare into beam
Laser radiation
Incorrect
7
EN
Publicidad
