Publicidad
Idiomas disponibles
Idiomas disponibles
MADE IN FRANCE
2 - INSTALLATION OF THE TORCH CONSUMABLES :
Before changing the consumables, cut the power supply using the interrupor behind the machine.
To use the torch, a complete set of consumables must be installed in the correct order: electrode, diffuser, tip and nozzle.
MACHINE OPERATION
1 - PLACE THE EARTH CLAMP ON THE PART TO CUT
Ensure proper electrical contact and do not to put the cable on the cutting trajectory.
Warning: painting prevents contact between the metal part and the earth clamp, do not forget to sand.
2 - CHECK THE PRESENCE OF ALL THE CONSUMABLES ON THE TORCH AND CONNECT AS FOLLOWS :
3 - START THE MACHINE and check that the power light (1) is on.
4 - SETTINGS PANEL (FIG-2)
Green indicator (1)
When the machine is powered, the indicator is on. In case of power cut, the green indicator switches off and the machine switches off.
Yellow indicator (2)
Overheating : in this case, the yellow indicator lights up. Wait for a few minutes for the indicator to switch off and the machine will be functioning.
Overheating of the power supply : in this case the yellow indicator flashes. Unplug the machine (using the power cable) and reconnect.
5 - SETTING FOR THE AIR PRESSURE
In order to improve cutting performance, make sure air pressure is set to an appropriate level. To check this :
- Press the trigger of the torch (the arc starts).
- Release the trigger, the arc stops but the air continues to flow for roughly 15 seconds.
- During this period, adjust the air pressure to 5 bar using the air scroll wheel (5).
- To use on low power below 10 A, set the pressure to 3 bars.
6 - CURRENT SETTING (FIG-2)
Use the adjuster
to set the current relative to the thickness and type of the metal sheet. Adjusting the pressure at maximum power should cover
all other normal cutting situations.
7 - STARTING THE CUTTING MODE (FIG-2)
The PLASMA cutting machine is equipped with pilot arc system. This system allows starting the arc without touching the piece to cut. You have 2
ways to cut your piece :
▪ Press the trigger > pilot arc formation > cutting by contact with the piece.
▪ Contact with the piece > press on the trigger > immediate cutting
▪ During the cutting, make sure to maintain the contact between the nozzle and the piece to cut.
SAFETY TRIGGER
The torch is equipped with a safety latch to prevent accidental use: Unlock it and pull the trigger as below:
1
Wear appropriate protective equipment. Stay away from the tip of the torch. Keep your hands away from the cutting trajectory. Never
point the torch towards you or another person.
16
PLASMA CUTTER 30 FV
Nozzle
Tip
2
Diffuser
Electrode
3
EN
Torch
Publicidad
