Medtronic GUARDIAN 4 Manual Del Usuario página 14

Installing a battery in the charger
To install a battery in the charger:
1. Push the battery cover in and slide it off (as shown in image A in step 3).
2. Insert a new AAA alkaline battery. Make sure the + and - symbols on the battery align with these
same symbols shown on the charger.
3. Slide the cover back on the charger until it clicks into place (as shown in image B in step 3).
Charging the transmitter
CAUTION: Always charge the transmitter before inserting the sensor. A depleted transmitter
does not function. A fully charged transmitter works at least seven days without recharging.
A depleted transmitter can take up to two hours to recharge.
CAUTION: Do not store the transmitter on the charger for more than 60 days. Disconnect and
reconnect to the charger to re-charge again before use. If the transmitter is left on the charger
for more than 60 days, the transmitter battery will be permanently damaged.
To charge the transmitter:
1. Push the transmitter and the charger together to connect the transmitter to the charger.
Translation Trigger
14