Receiving The Memorized Stations; Storing The Station Names -Station Memo - Sony WX-C770 Manual De Instrucciones

Receiving the memorized
stations
1
Press (TUNER) repeatedly to select the
band (FM or AM).
2
Press the number button ((1) to (10))
momentarily where the desired station is
stored.
If you cannot tune in a preset
station
Press either side of (SEEK/AMS)
momentarily to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Press either side of (SEEK/AMS)
repeatedly until the desired station is
received.
Note
EN
If the automatic tuning stops too frequently, press
(SHIFT), then press (9) (P MODE) repeatedly until
"Local" (local seek mode) is displayed. Then press
(10) (n) to select "Local on." Press (SHIFT).
Only the stations with relatively strong signals will
be tuned in.
Tip
If you know the frequency of the station you want
to listen to, press and hold either side of
(SEEK/AMS) for two seconds until the desired
frequency appears (manual tuning).
If FM stereo reception is poor
— Monaural Mode
1
Press (SHIFT), then press (9) (P MODE)
repeatedly until "Mono" appears.
2
Press (10) (n) repeatedly until "Mono
on" appears.
The sound improves, but becomes
monaural ("ST" disappears).
3
Press (SHIFT).
To go back to normal mode, select
"Mono off" in step 2 above.
Changing the displayed items
Each time you press (DSPL), the item changes
as follows:
" Station name*
* If the station name is not stored, "NO Name"
appears in the display for one second.
14
" Frequency " Clock
Storing the station names
—Station Memo
You can assign a name to each radio station
and store it in memory. The name of the
current station appears in the display. You can
store up to eight characters for each station.
Storing the station names
1
Tune in a station whose name you want
to store.
2
Press (LIST) for two seconds.
F M 1
PRESET
3
Enter the characters.
1 Rotate the dial clockwise to select the
desired characters.
(A n B n C n ··· Z n 0 n 1 n 2 n
··· 9 n + n – n * n / n \ n > n <
n . n _ )
F M 1
PRESET
If you rotate the dial counterclockwise,
the characters appear in the reverse
order.
If you want to put a blank space
between characters, select "_" (under-
bar).
2 Press (10) (n) after locating the
desired character.
The flashing cursor moves to the next
space.
F M 1
PRESET
If you press (7) (N), the flashing cursor
moves to the left.
3 Repeat steps 1 and 2 to enter the
entire name.
4
To return to normal radio reception,
press (LIST) for two seconds.
Tip
To erase/correct a name, enter "_" (under-bar) for
each character.
_ _ _ _ _ _ _ _
W _ _ _ _ _ _ _
W _ _ _ _ _ _ _