Elcometer NDT MTG6 Guia Del Usuario página 33

17 SPARES & ACCESSORIES (continued)
When choosing a transducer, the frequency, diameter and material
under test should be considered.
Part Number
TXC1M00EP-2
TXC2M25CP-2
TXC2M25EP-2
†
TXC3M50EP-1
†
TXC5M00BP-4
TXC5M00EP-3
†
TXC5M00EP-4
TXC5M00CP-4
†
TXC5M00CP-6
#
TXC5M00CP-8
†
TXC7M50BP-3
‡
TXC7M50CP-4
†
TXC7M50CP-5
TXC10M0BP-1
TXC10M0CP-4
Key
C/I = Cast Iron
G/F = Glass Fibre
G = Glass
†
Coating thickness, high damped transducer utilising ThruPaint™ technology. Suitable for use with 'Echo-
Echo ThruPaint™' measurement mode only - see Section 4.6 'Selecting the Measurement Mode' on
page en-8.
#
High temperature transducer, suitable for measuring hot surfaces up to 343°C (650°F).
‡
Extra resolution transducer with increased near surface resolution, ideal for use on thin substrates.
Other transducers are available which can be connected to MTG
gauges using a transducer adaptor - see Section 17.4 'Transducer
Adaptor' on page en-35. For a complete list of transducers, visit
elcometerndt.com
www.elcometer.com
Frequency Diameter
1.0MHz 1/2"
2.25MHz 1/4"
2.25MHz 1/2"
3.5MHz 1/2"
5.0MHz 3/16"
5.0MHz 1/2"
5.0MHz 1/2"
5.0MHz 1/4"
5.0MHz 1/4"
5.0MHz 1/4"
7.5MHz 3/16"
7.5MHz 1/4"
7.5MHz 1/4"
10.0MHz 3/16"
10.0MHz 1/4"
P = Plastics
T/G = Thin Glass Fibre
A = Aluminium
Suitable for Measuring
C/I P T/P G/F T/G S
  
  
  
  









T/P = Thin Plastics
S = Steel
T = Titanium
R
G A T
 
 
 
 
 
 
  
  
  
  
  
en-32