Publicidad
Idiomas disponibles
Idiomas disponibles
5 SETTING LIMITS - MTG8 (continued)
When created, limits are stored in the gauge limit memory and are
available for future selection, see Section 5.3.
Saved limits can be renamed and the values can be amended at any
time, see Sections 5.4 and 5.5.
5.1 CREATING LIMITS FOR INDIVIDUAL READINGS
1
Press Menu/Limit Memories/Create Limit Memory/Set Upper
Limit (or 'Set Lower Limit').
2
Use the
3
If required, repeat Step 2 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
4
When all values have been set, use the
'Save Limit Memory n' and press 'Select' to save.
Limits are specific to the measurement mode in use when created.
5.2 CREATING LIMITS FOR A NEW BATCH
1
Press Batch/New Batch/Batch Limits/Create Limit Memory/
Set Upper Limit (or 'Set Lower Limit').
2
Use the
3
If required, repeat Step 2 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
4
When all values have been set, use the
highlight 'Save Limit Memory n' and press 'Select' to save.
Limits are specific to the measurement mode in use when created.
Batch limits can be viewed at any time via Batch/Review Batch/Batch
Information.
5.3 SELECTING SAVED LIMITS
1
Press Menu/Limit Memories/Select Limit Memory or when in
Batching, press Batch/New Batch/Batch Limits/Select Limit
Memory.
2
Use the
press 'Select'.
Only the limits specific to the measurement mode in use are available for
selection.
Batch limits can be viewed at any time via Batch/Review Batch/Batch
Information.
When a limit memory is in use,
measurement screen, where n = the limit index number.
www.elcometer.com
softkeys to set the required value and press 'Set'.
softkeys to set the required value and press 'Set'.
softkeys to highlight the limit memory required and
is displayed to the right of the
softkeys to highlight
softkeys to
en-10
R
Publicidad
