Elcometer NDT MTG6 Guia Del Usuario página 7

4 GETTING STARTED (continued)
If 'None' is selected for one half and
'Readings', 'Run Chart' or 'B-Scan' (MTG8
only) for the other half, the readings, run chart
or B-Scan will fill the whole screen. If any
other combination of options is selected; the
data will be shown in the top or bottom display
as specified.
None; No information is displayed.

Readings; The reading value is

displayed.
Selected Statistics; Up to 8 statistical

values can be displayed as defined by
the user via Display/Statistics/Select
Statistics. Select from:
MTG6: Number of Readings, Mean,
Lowest Reading, Highest Reading,
Standard Deviation.
MTG8: MTG6 list plus Low Limit Value,
Number Below Low Limit, High Limit
Value, Number Above High Limit,
Range, Nominal Value.
Run Chart; A line trend graph of the last

20 measurements which is updated
automatically after each reading.
Bar Graph; An analogue representation

of the current measurement value
together with the highest (Hi),
and average (X) reading. The graph is
updated automatically when each reading
is taken.
Readings & Differential (MTG8 only);

The last reading is displayed together
with the variation from the nominal value
set via Menu/Limit Memories/Create Limit
Memory/Set Nominal.
a
Not available in 'Scan Mode' - see Section 10.3 'Taking a Reading in Scan Mode' on page en-22.
www.elcometer.com
lowest (Lo)
a
Readings
Selected Statistics
Run Chart
Bar Graph
Readings & Differential
R
en-6