Publicidad
Idiomas disponibles
Idiomas disponibles
1.
In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with
a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before
starting the engine. Refer to Engine Owner's Manual for correct procedure.
IMPORTANT: Ethanol Shield
and prevent ethanol related problems in power equipment. Follow the instructions on the
container and add to the gasoline.
Check engine oil level. See Engine Owner's Manual for correct procedure.
2.
3.
Connect the water hose to the water source. Turn the water source on to remove all
air from the hose. When a steady stream of water is present, turn the water source
off.
4.
Verify the filter screen (M) is in water inlet of pump. NOTE: Convex side faces out.
Connect water source (N) to pump inlet (J). NOTE: Water source must provide a
5.
minimum of 5 gallons per minute at 20 psi.
6.
Connect high pressure hose (C) to pump outlet (I).
10
M
WARNING: To reduce the possibility of contamination always
protect against backflow when connected to a potable water system.
Choose the correct nozzle for the job to be performed. See How To Use spray
7.
Wand instructions in this section. NOTE: If applying a chemical or cleaning
solution, see How To Apply Chemicals/Cleaning Solvents instructions in
this section.
8.
Turn water source on.
NOTICE: Risk of property damage. Failure to do so could cause damage to the pump.
9.
Remove all air from the pump and high pressure hose by depressing trigger until a
steady stream of water is present.
10. Start engine. See Engine Owner's Manual for correct procedure.
WARNING: Risk of unsafe operation. If engine does not start after
two pulls, squeeze trigger of gun to relieve pump pressure. Pull starter
cord slowly until resistance is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm injury.
11. Depress trigger on gun to start water flow.
WARNING: Risk of unsafe operation. Stand on a stable surface and
grip gun/spray wand firmly with both hands. Expect the gun to kick
when triggered.
12. Release trigger to stop water flow.
(sold separately) is a fuel stabilizer that helps eliminate
TM
NOTICE: Use of fuels with greater than 10% ethanol are
not approved for use in this product per EPA regulations
and will damage the unit and void the warranty.
11
17 - ENG
12
J
I
N
C
Publicidad
