Publicidad
Idiomas disponibles
Idiomas disponibles
DANGER: To reduce the risk of injury, read the pressure washer instruction manual
and the engine instruction manual before operating pressure washer.
Wheel Installation
Slide the axle pin through the wheel and one of the flat washers. Slide the axle pin
through the hole in the frame and other flat washer. Slide clip through hole in axle pin
to secure wheel in place. Repeat same steps for second wheel.
NOTICE: Keep machine level during wheel installation process.
Do not tilt, tip over, or turn upside down to install wheel kit. May
cause damage!
Install the
A
Handle
Place handle
onto frame, depress the
snap buttons, and slide
the handle assembly
onto the frame until snap
buttons snap into place.
IMPORTANT: Ethanol Shield
and prevent ethanol related problems in power equipment. Follow the instructions on the
container and add to the gasoline.
QUICK SETUP GUIDE
Add/Check Oil
B
The engine is
shipped without
oil. Before starting engine,
add the oil. Check
oil level prior to each
use. Refer to Engine
Owner's Manual for
complete procedure.
(sold separately) is a fuel stabilizer that helps eliminate
TM
8- ENG
Add Gasoline
C
In a well ventilated
outdoor area
add fresh, high quality,
unleaded gasoline with
a pump octane rating
of 86 or higher. Do not
overfill. Wipe up spilled
fuel before starting the
engine. Refer to Engine
Owner's Manual for
complete procedure.
Publicidad
