Descargar Imprimir esta página

Philips HR7978 Manual Del Usuario página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
3
Press the insert onto the insert holder until
it locks in position with a click.
Citrus press
Before you start, make sure that you assemble
according to Fig. 6.
Note
Put the sieve for citrus press on the shaft in the bowl.
Make sure that the projection on the sieve is locked
in the slot of the bowl handle. When the sieve is fixed
correctly, you hear a click.
Press the citrus fruit onto the cone. Stop pressing to
remove the pulp from the sieve if necessary. When
you finish pressing or want to remove the pulp, turn
the knob to 0 position and remove the bowl from the
appliance with the accessories on it.
Meat mincer (HR7958/
HR7978 only)
Before you start, make sure you assemble
according to Fig. 7-1.
The meat mincer is intended for mincing raw or
cooked meat.
When the meat gets stuck in the hopper, follow
the steps below to reset:
1
Switch off and unplug the appliance.
2
Detach the hopper assembly.
3
Clear the blockage.
4
Reassemble the hopper.
5
Connect the power plug to the power
supply and reselect the desired speed.
Replace the gear
When the gear for the worm shaft is damaged,
use the extra one to replace it according to
Fig. 7-2.
Note
Never grind bones, nuts, or other hard ingredients.
Never use frozen meat! Before you grind the meat,
defrost it first.
Do not push too much meat or exert too much
pressure when pushing the meat into the hopper. This
can avoid overloading the appliance.
Tip
Remove bones, gristle, and sinews out of the meat to
avoid blockage during grinding.
Mill (HR7958/HR7978 only)
Before you start, make sure that you assemble
according to Fig. 8.
You can use the mill to chop/grind coffee
beans, peppercorns, nuts, herbs, dried fruits etc.
Dried fruits such as figs can be chopped and
use as toppings for yoghurt or spread for your
bread or biscuit.
For best results when processing dried black
Mission figs, use max of 85g at speed P for
3 seconds.
Note
Follow the recommended quantities, processing time
and speed for the ingredients as indicated in Fig 9.
Do not exceed the maximum level of the mill jar.
You can order a mill (under service code 96510070528
and 996510070501) from your Philips dealer or a
Philips service center as an extra accessory.
Tip
Before opening the mill with processed ingredients
1. Hold the mill jar upside down.
2. Tap the mill jar a few times.
3. Remove the blade assembly slowly.
EN
15

Publicidad

loading

Este manual también es adecuado para:

Hr7951Hr7954Hr7958Hr7974Hr7950