Greencut GTC220XE Manual De Instrucciones página 64

64
FRONT PART
STEP 2: ATTACH THE BRACKET AND HANDLEBAR ANCHOR
1. The bracket is placed on the outside of the transmission cover and should align the lower tubes.
2. Insert one 3/8"-16x1" screw each for each side of the bottom holes.
3. Put the 3/8"-16 nuts on each screw.
4. Insert a 3/8"-16x1" screw on each side into the upper holes of the handlebar at the desired height.
5. Tighten all nuts.
STEP 3: POSITION THE HANDLEBARS YOU ARE GOING TO WORK WITH
1. Insert four solidity screws into each hole.
2. Fit four nuts.
3. Tighten all nuts.
DEPTH
ADJUSTMENT
SUPPORT
NUTS
HEIGHT
ADJUSTMENT
SCREWS
BACK SIDE
DEPTH SETTING
SCREW
DEPTH
REGULATOR
HEIGHT
ADJUSTMENT
SCREWS
HEIGHT
ADJUSTMENT
HOLES
TRANSMITTER
COVER