Belkin OmniView PRO Serie Manual Del Usuario página 17

F1D116_OSD_AM_man.qxd 4/20/00
Usage
SCAN TIME:
Amount of time the OmniView
on one port before switching to the next
port when in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection.
Note: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are
The BANK/SCAN Button:
4:07 PM Page 15
(continued)
PRO stays
™
set on the MASTER unit only, and need not be set on the slave units.
Pressing the BANK/SCAN button cycles you through all of the active BANKs (if
there are slave units present) and then puts the unit into AutoScan mode. If the
unit is a single MASTER unit, pressing the button immediately invokes AutoScan
mode. This is evident by a long BEEP, followed by two short beeps.
SCAN TIME: SCAN TIME:
I I I 15sec I 15sec I 30sec I 30sec
7sec 7sec
DISPLAY TIME: DISPLAY TIME:
I 7sec I 7sec I 15sec I 15sec I I
30sec 30sec
[↕]: SELECT [↕]: SELECT
(INS): RENAME (INS): RENAME
(Enter):COMPLETE (Enter):COMPLETE
(Esc): (Esc): Exit Exit
15
I 60sec I 60sec
I 60sec I 60sec
En