Belkin OmniView PRO Serie Manual Del Usuario página 20

F1D116_OSD_AM_man.qxd 4/20/00
Troubleshooting
• Check your computer/motherboard documentation making sure that the serial
• Plug in a serial mouse directly to your computer, and reboot. If the mouse pointer
• Try a different PS/2 mouse at the console.
• Make sure the mouse (at the console) is a true PS/2 mouse. A combo mouse will
• Check to make sure that the power adapter is plugged in and is working properly.
• RESET the OmniView
Q: When I switch from one port to another, mouse movement is completely
erratic.
A: • RESET the OmniView
• Make sure you do not have more than one serial mouse driver loaded. Make sure
• Avoid using a specialized mouse at the console such as a cordless mouse,
• Make sure you do not have any other mouse drivers loaded in your config.sys or
• Avoid moving the mouse or pressing the mouse buttons when switching ports.
• Reset the mouse to resume proper mouse movement simply by unplugging the
Q: The wheel on the IntelliMouse
A: • The Integrated Mouse Conversion Technology converts only the standard PS/2
4:07 PM Page 18
ports are enabled, and that there are no IRQ or base address conflicts with other
serial ports or modems.
still does not move, then there may be no serial mouse drivers installed, or the
serial port on your computer may have other conflicts or problems.
work just as long as it is set for PS/2 mode with the correct adapter. A serial-only
mouse with a combo mouse adapter WILL NOT work.
It must be 12VDC, 1000mA minimum. Make sure the power switch is on.
™ PRO by simultaneously pressing the BANK/SCAN and
CHANNEL buttons on the front panel. Access the OSD menu again and it should
have re-detected all the active ports.
™ PRO by simultaneously pressing the BANK/SCAN and
CHANNEL buttons on the front panel. Access the OSD menu again and it should
have re-detected all the active ports.
that the driver is either for a Standard Serial or Microsoft
mouse.
scrolling mouse or mice with more than 2 operational buttons. Non-standard
mice often use non-PS/2 proprietary mouse protocol.
autoexec.bat files.
mouse from the OmniView ™
signals which are the buttons and the x and y coordinate movement, but not the
wheel movement or wheel button. This is because the wheel and wheel button
data use non-PS/2 protocol.
(continued)
PRO for about 2-3 seconds, and plugging it in again.
® does not work on my computer. Why?
18
® -compatible serial