Futurelight PSC-1200 MK-2 Manual Del Usuario página 48

is a hexadecimal number value "01-FF".
Adjust the desired DMX value by pressing [UP] or [DN].
Press [ENTER] in order to edit other channels of this scene.
Repeat above steps until you finish setting all the DMX values for all channels of this scene.
Once all the channels completed, the display will flash "tIME".
Press [ENTER] to edit the time needed, the display shows "t--X","X" stands for the time needed to run the
current scene, value "1-9". For example, "t--2" means you need 2 seconds to run the current scene.
Adjust the desired time by pressing [UP].
Press [ENTER] to save the settings for the scene you are editing, the display will change to the next scene
automatically.
Repeat above steps to edit and other scenes, you can edit and save a maximum of 48 scenes.
Press [EXIT/DN] to exit. The number of steps can be defined under "STEP" and the scenes can be called
up under "RUN"
b) Editing via the external controller
Call up the first scene in your controller now.
Select "SC01" by pressing [UP] button.
Press [ENTER], the display shows "SC01".
Press [ENTER], the display shows "C-01".
Select "CNIN" by pressing [UP].
Press [ENTER], the display shows "OFF".
Press [UP], the display shows "ON".
Press [ENTER], the display shows "SC02". You successfully downloaded the first scene.
Adjust the Step-time as described above.
Call up the second scene in your controller now.
Repeat steps 5-11 until all desired scenes are downloaded.
Press [EXIT/DN] to exit. The number of steps can be defined under "STEP" and the scenes can be called
up under "RUN"
- Define the number of steps in Run
With this function you can define the number of steps in the
Program Run.
Select "STEP" by pressing [UP] button.
Press [ENTER], the display shows"S-XX", "X" stands for
the total amount of steps you want to save, so you can call up
to 48 scenes in "RUN". For example if the "XX" is 05, it
means that "RUN" will run the first 5 scenes you saved in
"EDIT".
Press [ENTER] to save and exit.
- Editing the channels of the individual scenes
With this function you can edit the program to be called up in
Run.
a) Editing via the Control Board
Select "SC01" by pressing [UP] button.
Press [ENTER], the display shows "SCXX", "X" stands for
the scene no. to be edited.
Change the scene no. by pressing [UP].
Press [ENTER], the display shows "C-XX", "XX" stands for
the channel no. Such as "C-01", it means you are editing
channel 1 of the selected scene.
Select the channel no. you would like to edit by pressing
[UP].
Press [ENTER] to enter editing for the selected channel ,
the fixture reacts to your settings. The display shows the
DMX value of the edited channel. Such as " 11XX", it stands
for channel 11 of the current scene, the DMX value is XX , XX
48/99 00024217.DOC, Version 1.4