Maytag MAV-3 Guía De Uso Y Cuidado página 7

STEP 4
Select Cycle
To select a cycle, push the control dial in (off position)
and turn it to the right (clockwise) until the pointer is at
the soil level needed for the wash load.
Important: For optimum fabric care, the appropriate
wash and spin speed for the load type must be
selected using the wash/spin speed knob.
Regular Cycle
This cycle provides up to 14 minutes of agitation.
Select the Regular Wash/Spin Speed setting.
Wrinkle Control
This cycle is designed for most loads. For lightly to
normally soiled garments. Select the Wrinkle Control
Wash/Spin Speed setting.
Delicates Cycle
Delicates is designed for items requiring delicate wash
action. Select the Delicate Wash/Spin Speed setting.
Soak Only
(select models)
Provides 4 minutes of agitation, then soak. Avoid
extended soaking – soak for 30 minutes or less.
The control dial must be manually advanced to a spin
setting to spin and drain the water.
STEP 5
Select Options
Extra Rinse
When the knob is in the On position, an additional
rinse at the end of the Regular, Wrinkle Control and
Delicates cycles is provided to more completely
remove laundry additives, suds, perfumes, etc.
End of Cycle Signal
The end of cycle signal will sound once the cycle is
completed. The end of cycle signal can be canceled by
setting the switch to Off.
STEP 6
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial in. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed in (off position) when you change the setting.
Note:
Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
Control features vary by model.
(if desired)
(select models)
6