Ending The Treatment - Pari LC PLUS Instrucciones De Use

Using the LC interrupter
If the LC interrupter is attached, aerosol is not generated until
the interrupter button is pressed. Proceed as follows to inhale
and to interrupt aerosol generation when breathing out:
• Press the interrupter button to
generate aerosol.
Info: If the button cannot be
pressed, it is locked and the
LC interrupter has been set for
permanent nebulising. In this
case, unlock the interrupter
button by turning it counter-
clockwise as far as it will go.
• Release the button to interrupt aerosol generation.
If you want to use the permanent nebulising function even with
the LC interrupter fitted:
• Turn the interrupter button
clockwise as far as it will go.
Æ The aerosol is generated per-
manently (permanent
nebulising).
Inhaling with accessories
Inhalation with accessories (e.g., masks) is described in the in-
structions for use of the respective accessory.

3.3 Ending the treatment

To end the treatment, proceed as follows:
• Switch the compressor off.
• Place the nebuliser back in the holder on the compressor.
• Disconnect the power plug from the mains socket.
Complete disconnection from the mains is only certain when
the power plug has been unplugged from the socket.
– 19 –